-
ESXDOS v0.8.0 released (with NMI Browser)Hello, To celebrate the speccy's 30th birthday, here's the latest version of ESXDOS for DivIDE users. The full changelog is too long to post here, s…
... used only for install 16kB ROM images. Example:
... .install sebasic.rom
But this command ... connect new 16kB rom image instead ZX rom. After load rom image you must ... allram mode and start new rom.
Also ... -
Incorrect Spectrum +3 emulation: different results on Fuse and SpecEmuWhen developing and testing [URL="http://www.worldofspectrum.org/infoseekid.cgi?id=0027591"]Rotatrix[/URL], I noticed different results on Fuse and S…
... that rotatrix behavior depends on ROM image.
With Spectaculator timings and ... +3 ROM it will works incorrectly (with ... /> With Spectaculator timings and 128 ROM it will works good...
Incorrect Spectrum +3 emulation: different results on Fuse and SpecEmuWhen developing and testing [URL="http://www.worldofspectrum.org/infoseekid.cgi?id=0027591"]Rotatrix[/URL], I noticed different results on Fuse and S…
... that rotatrix behavior depends on ROM image.
With Spectaculator timings and ... +3 ROM it will works incorrectly (with ... /> With Spectaculator timings and 128 ROM it will works good...
Incorrect Spectrum +3 emulation: different results on Fuse and SpecEmuWhen developing and testing [URL="http://www.worldofspectrum.org/infoseekid.cgi?id=0027591"]Rotatrix[/URL], I noticed different results on Fuse and S…
... that rotatrix behavior depends on ROM image.
With Spectaculator timings and ... +3 ROM it will works incorrectly (with ... /> With Spectaculator timings and 128 ROM it will works good...
Spectrum Playbasic EMULATORHi, Im new to the site and im writting a spectrum emulator in Playbasic :-o Its halfway complete. But i need help with emulating sound!? Anyone care…
... the first one in the ROM image, and work through them in ...Spectrum Playbasic EMULATORHi, Im new to the site and im writting a spectrum emulator in Playbasic :-o Its halfway complete. But i need help with emulating sound!? Anyone care…
... the first one in the ROM image, and work through them in ... so i canstep through the rom and see all the results ...Spectranet updateHi all It's been a busy summer, and in any case I've wanted a little bit of a break from doing Speccy stuff to avoid it getting old (pun intended). …
... bootloader program that fetches a rom image over the network and shuffles ... a 48k machine with the ROM replaced by an SRAM chip ...Checksum routine wantedI wish to make a program that verify integrity of a Multiface 1 ROM. It is possible to compare each byte of the ROM against a binary dump, but this i…
... trying to create a different ROM image which meets your integrity check ... people accidently using a different ROM?
If the latter ...What is this???? :OLooking in ebay, I found this!: [url]http://www.ebay.it/itm/Simulatore-di-Spectrum-per-Commodore-64-128-Retrocomputer-cassetta-/290861910864?pt=Retr…
There was also a Speccy emulator for the CPC which required a Spectrum BASIC ROM image to run.. circa 1993/1994.What is this???? :OLooking in ebay, I found this!: [url]http://www.ebay.it/itm/Simulatore-di-Spectrum-per-Commodore-64-128-Retrocomputer-cassetta-/290861910864?pt=Retr…
[QUOTE=zeropolis79;682886]There was also a Speccy emulator for the CPC which required a Spectrum BASIC ROM image to run.. circa 1993/1994.[/QUOTE]
Is there a download link?
I'd love to try it out.The Disciple clone... doable?Hi. As a spectrum user in the 80's this was the dream interface all-in-one for me. I have a 48k+ and planning on get a 128K toast-rack later. Anyway…
... read that there was several rom versions, v1, v2 ... seen the DISCiPLE v3.0 ROM. People keep labelling it ... RAM. Actually, the DISCiPLE ROM images that I've seen ... that half of the ROM image is missing! Might it ... missing half of the DISCiPLE ROM (if it is missing ...The Disciple clone... doable?Hi. As a spectrum user in the 80's this was the dream interface all-in-one for me. I have a 48k+ and planning on get a 128K toast-rack later. Anyway…
... Severino;684501]I opened the rom from EightyOne. It's a ... actually had an 8 KiB ROM image! IMO, the [I]right[/I ... sum of the 8 KiB image that you're referring to ... on until filling a 16K rom. It's empty, not " ... see a 16 KiB DISCiPLE ROM you have absolutely no way ...The Disciple clone... doable?Hi. As a spectrum user in the 80's this was the dream interface all-in-one for me. I have a 48k+ and planning on get a 128K toast-rack later. Anyway…
... 2 copies of the same rom?[/QUOTE]
For what ... use only an 8 KiB ROM image, which is effectively the same ... 8 KiB ROM's contents in a 16 KiB image... and this ... code so that the DISCiPLE ROM/RAM is [I]not[/I ...The Disciple clone... doable?Hi. As a spectrum user in the 80's this was the dream interface all-in-one for me. I have a 48k+ and planning on get a 128K toast-rack later. Anyway…
... RAM with the ROM contents, and using an image of the DISCiPLE ... /> If the RAM (containing a ROM image) started off at #0000, then ... and KSCAN_RES would keep the ROM image (in RAM) at #0000 ( ... />
If the ROM (containing a RAM image) started off at #0000 ...The Disciple clone... doable?Hi. As a spectrum user in the 80's this was the dream interface all-in-one for me. I have a 48k+ and planning on get a 128K toast-rack later. Anyway…
... RAM with the ROM contents, and using an image of the DISCiPLE ... ]If the RAM (containing a ROM image) started off at #0000, then ... and KSCAN_RES would keep the ROM image (in RAM) at #0000 (instead ... =zub;684850]If the ROM (containing a RAM image) started off at ...The Disciple clone... doable?Hi. As a spectrum user in the 80's this was the dream interface all-in-one for me. I have a 48k+ and planning on get a 128K toast-rack later. Anyway…
... ! So on bootup, the ROM would contain the ROM image, but start at ... entire 16 KiB image as though it were a ROM image. The high ... memory mappings.
[*]Having the ROM image loaded into RAM and a ... RAM pre-load image loaded into ROM.
[/LIST]
< ...DIVIDE versus ZX128 ROMDivide interface use hardware mapping of extra memory on this fixed points in 48rom: #0000 - power-on/reset/rst0/software restart #0008 - syntax erro…
... memory for replace internal ZX128 rom + next chips (one GAL ... any ZX128 rom (32kB rom image) and use this rom instead internal ... zx rom. But all ...
I have modified ZX128 rom for better compatibility divide with ...Spectrum 128K +2 problemhello, i am try to repair my spectrum 128k +2 grey, i remove all ram chips and i have some new ones spares, now i have remove all ram chips, i want …
ROM to test RAM [URL="http:// ... to you.
The ROM in a grey +2 is ... EPROM is a 27C256. The ROM image needs to be programmed in ... .
This is because the ROM image is only 8k long, but ... an un-programmed section of ROM if the bank switching is ...Spectrum 128K +2 problemhello, i am try to repair my spectrum 128k +2 grey, i remove all ram chips and i have some new ones spares, now i have remove all ram chips, i want …
[QUOTE=1024MAK;687086]ROM to test RAM [URL=" ... you.
The ROM in a grey +2 is ... EPROM is a 27C256. The ROM image needs to be programmed in ... br /> This is because the ROM image is only 8k long, but ... an un-programmed section of ROM if the bank switching ...Rocky Gush Floppy Drive InterfaceI have a Rocky Gush Floppy Drive Interface which I would like to post the details under the Hardware section of the website. What is correct procedur…
...
The separate 'ULA' ROM and 'DOS' ROM images seem puzzling.
ROM. This seems quite ingenious ... logic, whereas using a ROM image allows arbitrary behaviour for each ... of the 16/48K Spectrum ROM's 16384 memory locations ...Circumspect - A Spectrum Emulator for learningThis is a project that I have been playing around with for a while. It must be said, I tend to have problems getting things finished where hobbies a…
... the user chose a custom ROM image. We could do the same ... and have the default ROM be Brazilian Portuguese, if this ... they select the model 1 ROM when they enable that setting ...Brazilian TK90X and TK95SpecEmu provides explicit support for Brazilian TK90X. Other emulators provide indirect support (perhaps the "Spectrum 48K NTSC" option in Fuse?). Al…
... 95 emulation with a custom ROM image, if there really are ... TK95" behavior, using "tk90x2pt.rom". Setting check-box to Spanish ... simply replace it with "tk90x2sp.rom".[/LIST][/QUOTE]
ROM is the only practical ...Brazilian TK90X and TK95SpecEmu provides explicit support for Brazilian TK90X. Other emulators provide indirect support (perhaps the "Spectrum 48K NTSC" option in Fuse?). Al…
... 95 emulation with a custom ROM image, if there really are ... to avoid UI inconsistencies between ROM selection and other settings ... behavior at 60Hz, using "tk90x2pt.rom" by default.
... behavior at 50Hz, using "tk90x2sp.rom" by default.[/LIST]
...New SNES cartridge project in KickstarterI dont know if someone has already posted this, but there is a project, a 4-in-1 cartridge for the Super Nintendo on its way, people are very support…
... be better to sell the rom image so you can use it ...DivIDE problems in spinI have the roms and the hdf image in zx spin and i ran the .tap file. now it shows there is no volumes what am i doing wrong ?
... DivIDE box.
[*]In the ROM image tab, select ESXIDE.BIN as ... 0 and select your HDF image (remember to have the ESXIDE ...Flashing the DivIDE plusToday I've tried to flash my good old DivIDE plus with esxDOS 85 (it already have esxDSO 80 on it). When I start the tap file it asks me to do someth…
... sytem must be same 8kB rom image with system flashed to all ...Flashing systems on DIVIDE interfacesSome peoples can't reflash eeprom chip in Divide interface (original Divide, Divide 2k11, Divide 57d2/57d3). EEPROM chip AT28C64B contain feature fo…
... .[/QUOTE]
Yes. Make ROM image for DIVIDE PLUS is easy ... to adress #6000(24576) in ROM image with length 512kB.
Here is ROM image 512kB for FLASH EPROM in ...DIVIDE PLUS - new memory mode DIVIDE128Divide PLUS contain 512kB sram + 512kB flash eprom. Memory paging in this device is enable on two different ports : 1) port #E3 is compatible with o…
... divide systems/memory - each rom page in row3 contain divide ... between rows. Rom pages in row3 must contain rom image of system)< ... pages in row3 must contain rom image of system)
- first ...
DIVIDE PLUS - 16kB ROM paging mode
[img]http ...DIVIDE PLUS - new memory mode DIVIDE128Divide PLUS contain 512kB sram + 512kB flash eprom. Memory paging in this device is enable on two different ports : 1) port #E3 is compatible with o…
... routine for install 8kB rom image of divide system to ...
LD HL,24576 ;rom image position in ZX ram
LDIR ;copy rom image with divide system from adress ... ram at adress 24576. Rom image must contain only new modified ...DivMMC EnJOY!Coming up... [IMG]http://benophetinternet.nl/hobby/vanmezelf/DivMMC_enjoy_first_render.jpg[/IMG]
... run main system in 8kB ROM and work with full 32kB ... mapram mode are new system rom image installed to divide ram page ... use this ram instead 8kB rom) and system can use only ... all other 24kB ram + 8kB rom image (last DEMFIR version). MAPRAM led ...
