War Cars Construction Set: reformatted for readability - original spread over
multiple panes of inlay
Scanned by juice@2008
####################################################

		WAR CARS CONSTRUCTION SET

		CLIVE BROOKER

THE GAME

CAR WARS (construction set) offers a truly computerised simulation of slot car
racing. All the thrills and spills of a Grand Prix championship combined with
the aggressive competition of stock car rally. The frustration of building
tracks that don't work has been taken away to leave you with hours of
unadulterated fun!

LOADING
1.	Connect a suitable cassette player to your Spectrum according to the
User Manual. THEN FOLLOW INSTRUCTIONS 3,4 AND 5 BELOW.

SPECTRUM 48/128 and PLUS 2 OWNERS
2.	Put the 48/128 and Plus 2 systems into 48K mode.
3.	Place the rewound cassette into the cassette player.
4.	Type LOAD "" on your Spectrum and press ENTER.
5.	Press PLAY on the cassette player.

NOTE: Full loading instructions can be found in your Spectrum Manual.

PLAYING THE GAME
Within the gigantic roadway system of the CAR WARS ARENA both you and your
computerised opponent seek the special flags located around the track in order
to collect as many points losing as few lives as possible. Each flag is worth a
minimum of 100 points, if after collecting six flags you have more flags than
your opponent you will be given a 100 point bonus for every extra flag you
possess. To assist each player you start out with two boulders which can be used
to block your opponent's path for a short time. Press FIRE to release a boulder,
only one boulder may be released at once.

THE FLAGS
	The rock flag	 Replenishes your rock supply (maximum of two).
	The car flag	 Awards an extra life (maximum of five).
	The bonus flag	 100 points.
	The chase flag	 Allows you to crash into your opponent without losing
a life or awards points for your closeness of proximity to your opponent.

THE CONTROLS 
	Keyboard
		Left	= XVN
		Right	= ZCBM
		Up	= Q to O
		Down	= A to L
		Fire	= 1 to 5

		Pause/Entry Mode	= P 

Kempston interface is automatically selected and overides the keyboard controls. 
Joysticks for interface II or 128K+2, use port 1.

THE CONSTRUCTION SET
Included in the CAR WARS is a built in track designer that allows you to create
up to five new tracks. To enter the design mode press FIRE. This accesses the
selection screen. By moving your joystick up or down select the design roadway
option and press FIRE. 

The selection screen will now show a list of tracks 1 to 5. Use your joystick to
select a track and press FIRE again. The top left hand screen will show a 1/64th
scale blank map and the top right hand screen one 1/64th square with a grid
cursor indicating the placement for a piece of track. Press FIRE to access the
design mode. From here on use I and 0 to move through the track pieces on the
selection screen at the bottom left of the screen, then move the grid cursor
using the joystick controls and press FIRE to place the piece under the cursor.
Repeat this process for each new piece of track you lay. When you have; finished
your track design press P, this will access the central selection screen again,
select design end and press FIRE. You are now back to the main menu which will
allow you to play the game.

DO'S AND DON'TS
Always make sure there are no loose ends to your track design. Never make up
tracks with less than ten corners in it as this will confuse the programme's
placement of the flags. If you design a bad track layout the programme will
automatically abort it and put 
you back into the design mode.

SAVING AND LOADING
To save the tracks and the current high score table select the save option on
the main menu, press RECORD and PLAY on your tape recorder, then press FIRE. The
loading procedure is the same but only requires you to press PLAY on your
recorder. Press BREAK to abort the SAVE/LOAD.
